Available diameter 4 / 6 / 8 / 10 / 12 mm
Please state the desired diameter.

Available diameter 4 / 6 / 8 / 10 / 12 mm
Please state the desired diameter.

Available diameter 4 / 6 / 8 / 10 / 12 mm
Please state the desired diameter.

Available diameter 4 / 6 / 8 / 10 / 12 mm
Please state the desired diameter.

Available diameter 4 / 6 / 8 / 10 / 12 mm
Please state the desired diameter.

This extension made of Aluminium screwed below or ontop the support for the multi-faceted head of the Lapida machine to be able to grind the grindle (Rundiste) at an angle of 90 degree.

Dimensions: 100 x 30 x 15 mm

(new model) for precise re-attachment and re-orientation of stones.
Made of cast Aluminium with V-grooveand Dopp-pin-attachments.
New is one rigid and one movable putty pen lock mechnism, such that the stone can be repositioned and oriented precisely and without torsion.

For the precision multi-faceted head.
Partitions 22, 60, 63, 64 (bei Facettenkopf enthalten), 96

This accessory to the shape grinder is indispensable if the shape grinder is to be used for grinding at vertically running discs
(left side of the LAPIDA or other machines).

Please enter the diameter of the holding bar!

Faceting head with angle scale and pointer, height adjusting mechanism, base and holding bar diameter 15 mm, stainless.
The 16 partitions disc is adjustable and suitable for all facet cuts with index 64 (shaft diameter of the Dopp pin 8 mm).
The board may be polished without reclamping with 0 degrees (see instructions in the book "Edle Steine schleifen").

Can be mounted to all HAMAG gemstone grinding machines as well as machines of different construction.

Includes base, holding bar 15 mm Ø and height fine tuner, 16 partitions disc and bolts M 10 for fixing.

For sawing and fine grinding of thin sections on the glass support to few hundredth milli meters thickness, with diamond discs or a cast iron disc with grinding powders.
The thin sections are used for photo slides or micro-photographs.

Suitable for all Lapida machines, the multi-faceting unit of the multimotors and for device of different type of construction. The thin section arm rails with an adjustable brass bushing on a thrust (purely axial or axial-radial) bearing.

Complete with foot stand, Holding bar diameter 20 mm, axial bearing and height fine tuner stainless steel, 10 glass support sheets (27 x 46) mm and bolts M10 for fixing including washers.